If you manufacture a product which contains polystyrene and are looking to increase the chemical resistance of your product in order to give you a competitive edge then contact Advanced Polymer Solutions regarding our patented chemical process we will develop a customized formulation based upon your flame resistance specifications.
Once we develop and thoroughly test the formulation it will become your property which can be patented under your name. APS can manufacture the final formulation in the desired quantities and supply the manufacturer with a pre-mixed, ready to use coating, additive or adhesive. flame resistance on polystyrene formulation can be added to the resin or developed as a coating.
Polystyrene flame resistant coatings are applied on the surface of substrates to improve the functional properties and durability. Conventional coatings need extensive surface preparation for adhesion and need to build up thickness for performance. This is not the case with APS’ coating formulations. Most APS coatings can be applied in one step with no or minimal surface preparation. In addition, due to the chemistry of APS’ chemical grafting process, thinner coatings can be used to achieve a higher degree of property performance. Delamination will not occur due to the chemical bond formed between the coating and the substrate with some subsurface penetration occurring through the use of molecular small and lightweight monomer.
Polystyrene flame resistant additives are added into the resin prior to extruding or molding in order to penetrate to matrix of the material.
Typical coating methods can be used such as dip, spray, roll, flow coat, etc. APS coatings can be formulated to be air dried, however, in the interest of time, heat or some energy source (i.e., UV or infrared lights) can be used.
APS can develop additives to incorporate into the raw material/resin prior to extruding or molding. In this case, the new properties will penetrate the matrix of the material. APS chemists will adjust the formulation to conform to the processing parameters used by the manufacturer. Due to the molecular bond formed by APS’ process, the new properties will not migrate and leach from the material over time, even under severe condition.
APS chemists have extensive experience in bonding the same or different substrates together. Materials that are difficult to adhere to are effectively bonded with APS’ process.Substrate failure will occur before adhesion failure. In addition, if two substrates with different coefficients of thermal expansion are bonded, an APS developed adhesive bonding action will not be affected. Such is not the case with conventional adhesives which cannot withstand the varying expansion and contraction of different substrates.
UL 94 Flammability Classification Tests for Plastic Materials
UL 94 is the standard applied by the American Underwriters Laboratories for the testing of the flammability and fire safety of plastic materials used in devices and appliances. The UL 94 HB (Horizontal Burning) tests the burning of a horizontal plastic specimen and the most demanding UL 94V (Vertical Burning) tests the burning of a vertical plastic specimen. Precise details of the equipment, conditions and test systems to be used can be found in the UL 94 standard. he length of the test specimen is 5″ (127 mm) and width 0.5″ (12.7 mm). The test sheet cannot be more than 0.5 (12.7 mm) thick. Lines are marked on the sheet at the 1″ and 4″ locations. The sheet is fixed horizontally at one end and tilted 45 degrees in the direction of the width, as shown in the diagram. The burner used is adjusted so that it forms a 1″ long blue flame. The flame is directed at an angle of 45 degrees to the front edge of the plastic sheet so that about 1/4 of the test specimen’s front edge is in the flame. The flame is applied for 30 seconds, after which it is removed. If the test specimen burns to the 1″ line before 30 seconds have passed, the flame is removed immediately. The test is carried out on three test sheets.
For additional information regarding grafting flame resistance on polystyrene
Please fill out the form below